Capturing Even the Smallest Time Losses Without Overburdening Operators
Time losses lasting only a few seconds present a particular challenge. A machine may stop briefly again and again, or each production cycle may take slightly longer than planned. Each individual deviation appears insignificant and is often too short to be assigned a cause manually as it occurs. Across many cycles and an entire shift, however, these deviations can add up to substantial losses.
These deviations often have a recurring cause: The specified cycle time does not reflect the production time that can actually be achieved, the material is temporarily more difficult to process or a new employee is not yet fully familiar with the process.
Cosmino ensures that these short periods of lost time are not overlooked: They are captured automatically as micro-stops and included in the analysis. The system can also define the duration from which an operator must assign a specific loss reason to a downtime.
To avoid burdening employees with classifying every single short event, micro-stops can be classified collectively at the end of the shift. A selected number of micro-stops, or the resulting loss time, can then be assigned to a loss reason. This is particularly useful when the short losses are mainly attributable to one or a few recurring causes.
In addition to short interruptions, Cosmino also considers deviations from the target cycle time. If the cycle time systematically deviates from the target over an extended period, the operator can record and explain a performance deviation directly in the data entry dialog. The deviation is then shown accordingly in reporting. No additional micro-stops are generated for the period concerned, because the slower or faster production and its cause have already been documented. This keeps the deviation transparent without counting it twice.